Payment & Shipping Terms:
|Application:||Fiber Optic Cable Stripping||Cable:||Suit For 2.0mm 3.0mm Indoor Cable|
|Power Source:||Pneumatic||Efficiency:||1200-1800 Pcs Per Hour|
|Air Source:||0.6—0.8MPa.||Power:||220V 50Hz|
fiber optic polishing machine,
fiber optic curing oven
Pneumatic Fiber Optic Cable Stripping Machine Remove Cable Coat Machine
1. This machine is mainly for the current optical communication industry of 2.0mm and 3.0mm indoor optical fiber flaying
2. This machine adopts PLC control system, accurate and fast
3. Touch screen operation is simple, easy to learn and easy to understand.
4. Stripping, cutting speed quick, stable performance, high accuracy, adjustable length (25mm-38mm).
5. The number of stripping and cutting optical cable is 1200-1800 pcs per hour.
6. traditional flaying with the pedal hand is developed into a direct insertion mode(sensor), which saves the energy and improves the efficiency
7. In the operation, the front and back motion shall be adopted, and the ordinary indoor 2.0mm and 3.0 mm optical cable can be used in the machine without changing the cutter, without the worry of the damage of the fingers.
8. With a double knife design, the flaying , cutting of the kevlar and opening mouth of cable are formed once, with high accuracy and quick peeling. The air blowing device can automatically remove the kevlar from the peeling.
1. Connect the inlet pipe with the air source 0.6—0.8MPa.
2. Plug the power cord into 220V 50Hz power supply
3. Open the switch to get the touch screen to work, and click "auto" (" manual mode "is only used when you need to adjust the length of cutting kevlar, etc.)
4. Insert the fiber cable into the feeding port directly and begin to peel the work. Repeat the work repeatedly (you should dial out the cable quickly when the Kevlar is cut )
5. parameter adjustment:
5.1 Adjust the overall peeling length of the optical cable: adjust the two fine nuts of the induction switch part to adjust the peeling length.
5.2 Adjust the length of cut aramid: adjust the two fine-tuning nuts at the lower right corner of the aramid device to adjust the cutting length of aramid.
5.3 Adjust the length of the outer skin opening: adjust the length of the glue head screw in front of the opening device to adjust the length of the outer skin opening, and the length of the glue head to expose the long opening is short, and vice versa.
6. Consumable replacement:
6.1 Aramid cut change: this machine adopt the way of aramid cut to cut out of the barometer touch screen switch skinning device
Cutting kevlar barometer air filter Incision knife Line pressing Power port aramid fiber optic cable, due to the service life of aramid cut co., LTD. (miller KS - 1, for example, the service life of the normal in 2-4 months), when not enough sharp scissors, aramid cut can directly replace (waft aramid device in a fixed aramid cut device, remove the aramid cut directly to the plastic handle, at the same time the handle end of the pair of scissors cut a small section to replace the original scissors)
6.2 Replacement of the outer skin opening blade: when the cable outer skin opening is interrupted, the open blade needs to be replaced. Specifically, the blade can be replaced at the position of the opening device (the blade adopts 9*0.4 aesthetic blade).
1. Air pressure: 0.6—0.8MPa
2. Power: 220V 50Hz
3. Weight: 25kg
4. Volume: 405×415×445mm
1. Keep clean for a long time. Open 2 front covers after use every day to clean up the waste.
2. After use, cut off the power and air source
stripping machine 1 set,
power line 1pcs,
Discharge tube 1pcs
Contact Person: Doris